James Alumbaugh
The Fab Fours Lifestyle Grill Guard is a well designed piece of equipment when it comes to body coverage and protection is has a very subtle aggressive look. With 3/16 steel and a great powder coat look this is quite a nice bumper. It accommodates room for a large winch as well as all of the wiring for lights. It came with lights prewired with factory plugs and pigtails if you are adding it to a jeep without factory fogs. Easy access to all attachments without sacrificing protection from any angle.
It Came with fogs but can easily be swapped for different HIDs or LEDs. It is also heavier that a factory or most other bumpers, but with a good suspension upgrade, it isn’t an issue. Not recommended for stock “sports” as would provide a “nosed down” look. Also, when on a trail this bumper tends to pick up quite a bit of debris on the back side of the bumper near the fogs/markers and takes of bit of time in the car wash to properly clean. However, this is not uncommon with a full width bumper.
I had one for several years until a traffic accident scuffed the powder coating. The bumper structure and alignment was not affected in the least while virtually destroying the pick up truck that failed to yield. The insurance company insisted that re powder coating to restore loss was not cost affective. Without hesitation I requested this design again as I was very please.
PRODUCT SPECS
The Fab Four JK Lifestyle Winch Bumper w/ Grill Guard is a stylish, high clearance winch bumper with integrated D-Ring mounts and lights. Design is focused on it’s strength and rock-clearing abilities. Designed to be the ultimate in functionally-stylish front end protection, the Fab Fours’ lifestyle bumper has set the new standard in Jeep customization.
- Enhances the visual impact of the Jeep
- Lightweight and stays close to filling the “stock envelope.”
- Tapered sides and bottom slides off obstacles.
- Injection molded Light cut-outs
- Fab Fours’ 90mm fog and 60mm turn indicator lights are included FREE with the bumper!
- Winch ready for 10,000 lb winches or smaller (Doesn’t accept the WARN Power Plant & WARN ZEON).
- 1″ D-Ring mounts.
- 3/16″ steel construction.
- 1 3/4” center tube and 1 1/2” outer tube, 120 wall DOM tubing
- 2 Stage Black Powder Coat or Bare Steel.
- Length: 63″ Height: 30″ Width: 20″ Weight: 115 Lbs
